The diamond die wire drawing is a range of pressure processing. In addition to producing very little dust, the volume changes little during the stretching process, so the volume of the

metal before and after stretching is substantially equal. LINKUT will supply the complete drawing solutions for your PCD wire die.

1) Wire drawing die for copper and aluminum rod (wire) materials drawing. When the other conditions are the same, the tensile strength of the drawn copper wire is larger than that of

the drawn aluminum wire, and the drawn aluminum wire is easily broken, so a larger safety factor should be taken when drawing the aluminum wire.

2) The tensile strength of the material. There are many factors for the tensile strength of materials, such as the chemical composition of the material, the calendering process, etc., and

the tensile strength is high when the tensile strength is high.

3) Degree of deformation. The greater the degree of deformation, the longer the length of the deformation section of the die hole, thus increasing the positive pressure of the die hole 

against the wire, the frictional force also increases, and the tensile force also increases. 

4) The coefficient of friction between the wire and the die hole. The greater the coefficient of friction, the greater the tensile force. The coefficient of friction is determined by the finish of 

the wire and mold material, the composition and quantity of the lubricant. 

5) The size and shape of the working area and the sizing area of the wire die hole. The larger the sizing zone, the greater the tensile force. 

6) The position of the wire mold. Improper placement of the wire mold or skewing of the mold base also increases the tensile force. It also makes the wire diameter and surface quality 

not up to standard.

7) External factors. The wire is not straight, the jitter of the wire in the process of drawing the wire, and the resistance of the wire release will increase the tensile force.